Drive Assembly - Epson EPL-N1600 Service Manual

EPSON EPL-N1600

4.3.3 Drive Assembly

1. Remove the Cover Side,E.(Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E.(Section 4.3)
6. Remove the C258MAIN Board. (Section 4.3.49)
7. Remove the Shield Assembly Bottom (E). (Section 4.3.44)
8. Remove the PWBA Hotaru. (Section 4.3.48)
9. Remove the Chassis Assembly PS. (Section 4.3.46)
10. Remove the wire harness from the Drive Assembly front plate (5).
11. Disconnect J2341 on the wire harness from the Solenoid Feed from
P234-1 on the wire harness from the Sensor Assembly-Size 1,E.
12. Remove the Lever Jam Clear, Spring-Hold Rod, Stopper Rod and
Spring Nip Pre-Registration (steps 6 and 7 of RRP 4.1.1).
13. Remove the Frame Assembly MBF.
14. Set the printer on the rear surface.
15. Remove the Roll Assembly Feed (2 and 3).
16. Remove the Actuator No Paper (4).
17. Return the printer to an upright position.
Rev. A
Chapter 4
18. Remove the four screws that secure the Drive Assembly to the
Frame.
19. Remove the Drive Assembly off of the Frame.
20. Slide the Roll Assembly Turn off of their shaft by pressing the latch.
Figure 4-9. "Drive Assembly" Removal
Disassembly and Assembly
4-112