DLQ-3000+
3.2.6.8 Paper Eject Lever Assembly
Step 1) Remove the printer mechanism. (See Section 3.2.6.1.)
Step 2) Remove right and left extension springs which are crossed from the right and left
ends of the paper eject lever assembly to the right and left frame assemblies,
respectively. Then remove the springs.
Step 3) Remove 1 E-ring fixing the paper eject lever assembly to the right frame assembly.
Step 4) Lift up the rear edge of the paper eject lever assembly and shift it left to release the
right end of the lever from the pin. Then remove the paper eject lever assembly.
Right and left extension springs are 2 different parts. Therefore, be sure to mount
them to the correct sides of the printer mechanism.
3-18
CAUTION
Figure 3-21. Paper Eject Lever Assembly
Rev. A