Cr Removal - Epson DLQ-3000 Service Manual

DLQ-3000+

3.2.6.12 CR Removal

Step 1) Remove the printer mechanism. (See Section 3.2.6.1.)
Step 2) Release the hooks fixing the head cable holder to the CR frame, and remove the
head cable holder along with the head FFC.
Step 3) Remove the head FFC from the head cable holder.
Step 4) Remove the grounding plate for FFC, and remove the head FFC from the printer
mechanism. (See Section 3.2.6.6.)
Step 5) Loosen the timing belt. (See Section 3.2.6.6.)
Step 6) Remove the CR motor assembly, and remove the timing belt. (See Section
3.2.6.6.)
Step 7) Remove the pressure spring between the left frame and the lower CR guide shaft
pushing the lower CR guide shaft.
Step 8) Remove 4 screws (CBS, 3X6) securing the CR frame to the printer mechanism.
Then remove the CR frame by moving it upward and then to the rear, releasing the
engagement with the sub belt pulley.
3-20
Figure 3-23. Head Cable Holder Removal
Figure 3-24. Pressure Spring Removal
Rev. A