3.2.6.13 CS Board Assembly Removal
Step 1) Remove the printhead. (See Section 3.2.1.1.)
Step 2) Remove the CR. (See Section 3.2.6.12.)
Step 3) Remove 1 screw (CBS, 3X12) securing the ribbon cartridge holder to the CR.
Step 4) Release 6 hooks fixing the ribbon cartridge holder to the back of the CR. Then
remove the ribbon cartridge holder.
Step 5) Disconnect harnesses for the PEW board assembly, color ribbon sensor assembly,
and CS motor assembly from the CS board assembly.
Step 6) Disconnect the FFC for the CS motor assembly from the ribbon cartridge holder,
and remove the CS board assembly from the CR.
Rev. A
Figure 3-29. Hooks at the Back of the CR
Figure 3-30. CS Board Assembly Removal
Disassembly and Assembly
3-23