Removing The Roll Media From The Printer - Gerber Jetster Owner's Manual

32 CHAPTER 3
Preparing for a Job
6 Feed the media forward by pressing the [SHIFT] + [ADVANCE] keys simultaneously
until the media reaches the cardboard core on the take-up system.
7 Fix the media on the empty cardboard core with self-adhesive tape strips in the middle
of the media. Then tape the left and right side of the media to the core.
8 Feed the media slightly forward (using [SHIFT] + [ADVANCE]) and wind it up on the
Roll Take-up System. Now you are ready to start printing. Once the printer has
printed approximately the amount shown in the following figure, the sensors will be
activated and the Take-up System will start winding up the media.
9 Once your print is finished and dry you can wind up your print by pressing the
manual feed button. If you want to wind up or wind off your print you can do this via
the forward [SHIFT+MENU] or reverse [SHIFT+RESOLUTION].
10 To sheet-off the print push the [CANCEL] button for 2 seconds. Use the [Value +] or
[Value -] keys to select Yes. Press [Enter] to confirm the sheet-off request.

Removing the roll media from the printer

Use the following procedure to remove the roll media from the printer.
To remove the roll media from the printer
1 After printing, open the cover, tilt the media hold lever UP and wind up the roll
media.
2 Stand behind the printer. Unlock the scroller receiver by pressing the lock lever down.
You can now lift the right side of the scroller and remove it from the printer.