Maintenance; Cleaning/Lubrication; Tool Holders Carriage Spindle - Gerber HS750 Plus User Manual

MAINTENANCE

This section includes instructions for routine cleaning and
lubrication to keep the HS750
well as instructions for fuse replacement.

Cleaning/Lubrication

Routine cleaning and lubrication should be done monthly or after
every 160 hours of use, whichever occurs first.
For cleaning , use isopropyl alcohol to clean dirty parts. When
using isopropyl alcohol, lubricate the parts immediately to prevent
corrosion .
Use a light oil (such as
noted.

TOOL HOLDERS CARRIAGE SPINDLE

Note: Do not lubricate the tool holders or spindle bore .
Clean the spindle bore and tool holders daily. There is a very
!
close fit between the pen, knife, and pounce wheel holders
and the carriage spindle bore. Any dirt or build-up in the bore
or on the tool holder restricts motion and can produce
inconsistent results.
Clean the spindle bore and tool holders with isopropyl alcohol
!
using a lint-free cloth on the tool holders and a cotton swab in
the bore.
plus
plotter in good working order, as

) for all lubrication, except as
3-IN-ONE
55