Table of Contents
Advertisement
SC-F7000 Series
User's Guide
Messages
Media Size Error
Load correct size media.
When a Maintenance Call/Service Call Occurs
Error messages
Maintenance Request
Replace Part Now/Replace Part Soon
XXXXXXXX
Call For Service
XXXX Error XXXX
Power off and then on. If this doesn't work,
note the code and call for service.
Problem Solver
What to do
The media currently loaded is not the correct width. Raise the media loading lever and
remove the media.
The narrowest width supported by the printer is 300 mm. Be sure the media is at least 300
mm wide.
If this message is displayed even though the media is the correct width, the printer may
print if Off is selected for Media Size Check.
"Printer Setup Menu" on page 73
U
What to do
A part used in the printer is nearing the end of its service life.
Contact your dealer or Epson Support and tell them the maintenance request
code.
You cannot clear the maintenance request until the part is replaced. A service call
occurs if you continue to use the printer.
A call for service occurs when:
❏
The power cable is not connected securely
❏
An error that cannot be cleared occurs
When a call for service has occurred, the printer automatically stops printing. Turn
off the printer, disconnect the power cable from the outlet and from the AC inlet
on the printer, and then reconnect. Turn on the printer again multiple times.
If the same call for service is displayed on the LCD panel, contact your dealer or
Epson Support for assistance. Tell them the call for service code is "XXXX".
79
Advertisement
Table of Contents
