Table of Contents
Advertisement
SC-F7000 Series
User's Guide
Basic Operations
Loading and Exchanging
Media
Loading Media
The procedure for loading media varies depending on
whether you are using the installed media feeding unit
or the optional heavy roll media system.
Follow the steps below when using the supplied media
feeding unit.
When the Heavy Roll Media Feeding Unit is installed,
see: U
"Using the Optional Heavy Roll Media Feeding
Unit" on page 28
!
Caution:
❏ Be careful not to trap your hands or fingers
when opening or closing the front cover.
Failure to observe this precaution could result
in injury.
❏ Secure the media in place by the following
procedure.
Injury may occur if the media falls.
❏ Do not rub your hands along the edges of the
media. The edges of the media are sharp and
can cause injury.
c
Important:
Load media immediately before printing. The
pressure rollers may crease media left in the printer.
The media may also become wavy or curled,
causing jams or resulting in the media coming into
contact with the print head.
Note:
For information on the media that can be used in the
printer, see:
"Supported Media" on page 86
U
Basic Operations
When the Standard Media Feeding
Unit Is Installed
This section describes how to load media when the
standard media feeding unit is installed.
!
Caution:
Because the media is heavy, it should not be carried
by one person. When loading or removing the
media, use at least two persons.
A
Turn on the printer by pressing the P button.
B
Loosen the roll holder fixing screws and adjust
the roll holders so that the gap between the two is
wider than the media.
Center the roll supports between the roll holders.
c
Important:
If the right holder handle shaft is not visible,
rotate the handle forward until it stops. The
media can not be properly loaded if the handle
shaft is not visible.
23
Advertisement
Table of Contents
