Table of Contents
Advertisement
SC-F7000 Series
User's Guide
You can print the amount of media remaining on the
leading edge of the roll before it is removed from the
printer and then enter this number the next time the
media is loaded for accurate information on the amount
remaining.
Note:
The printer does not calculate or display the amount of
media remaining when Off is selected for Remaining
Setup in the setup menu.
"Viewing and Changing Media Settings" on
U
page 32
The following section describes how to print the
amount of media remaining.
Buttons that are used in the following settings
A
Confirm that the printer is ready to print.
B
Press the M button, select Media Remaining in
the menu, and press the Z button.
C
Select Print Remaining Length and press the
Z button.
D
Press the Z button to print the amount of
media remaining.
Cutting Media
Use a cutter (available in the market) to cut the media
when printing is complete. This section described how
to use a cutter to cut the media.
Basic Operations
!
Caution:
When cutting media, be careful not to cut your
fingers or hands with the cutter or other blades.
Buttons that are used in the following settings
A
Confirm that the printer is ready to print.
B
Press the
printer will feed the trailing edge of the printed
media to a position over the cutter groove.
If you have printed the amount of media
remaining, press the u button to rewind the
media so that this information will remain on the
roll after the media is cut.
34
button and the Z button. The
Advertisement
Table of Contents
