Table of Contents
Advertisement
SC-F7000 Series
User's Guide
Pressing this button displays the Maintenance
menu, which contains such items as Nozzle Check,
Cleaning, Head Maintenance, and Waste Ink
Counter. This button is disabled during printing.
"The Maintenance Menu" on page 75
U
L
W button (pause/cancel button)
❏
The printer enters pause status if this is pressed while
printing. To release the pause status, press the W
button again, or select Pause Cancel on the screen
and then press the Z button. To cancel print jobs
being processed, select Job Cancel on the screen and
then press the Z button.
❏
Pressing this button when menus are displayed closes
the menus and returns the printer to ready status.
M
button (media feed button)
❏
When the printer is in the ready state, you can feed the
media to the cut position by pressing this button and
then Z.
"Cutting Media" on page 34
U
❏
When printing is in progress, you can use this button
to adjust media feed.
"Feed Adjustment" on page 46
U
Understanding the Display
A
Messages
Displays the printer's status, operation, and error
messages.
"When a Message is Displayed" on page 78
U
B
Media info
❏
From left to right, this display shows the selected
media, platen gap, media width, and media
remaining.
Introduction
❏
If a media setting bank number created with this
printer is selected as the print media, the number
(from 1 to 30) will be displayed. When RIP Settings is
selected, 0 will be displayed.
❏
The selected platen gap is shown as follows.
: 1.5
: 2.0
: 2.5
❏
The media remaining is not displayed if Off is selected
for Remaining Setup in the Media Remaining menu.
"The Media Setup Menu" on page 70
U
C
Chip unit status
The display changes as shown below when an error is
detected in the installed chip unit.
Normal
1 Status indicators
The chip unit status is indicated as follows.
: No error. Ready to print.
: An error occurred. Check the message
: The chip unit could not be recognized
: The chip unit requires replacement.
2 Ink color codes
15
Warning or error
on the screen, and clear the error.
or it is not compatible with the printer.
Or, the slider is not locked.
Check the on-screen message.
Replace the chip unit with one from a
new ink pack.
As it gets closer to time to replace the
chip unit,
will begin to flash.
Advertisement
Table of Contents
