Table of Contents
Advertisement
SC-F7000 Series
User's Guide
E
Lower the tensioner.
F
Confirm that the media is attached without
deformation.
As shown in the identified sections in the
illustration below, if the tensions of the left and
right edges of the media are different, the media
cannot be taken up correctly. If there is slack on
one side, repeat from Step 1.
Note:
As shown in the illustration below, you can confirm
differences in tension by lightly tapping on both
edges of the media.
Basic Operations
G
Press the d button to feed the media until the
take up roll core begins to turn.
c
Important:
The auto take-up reel unit will not function if
the tensioner is raised.
Removing the Take-up Roll
The procedure for removing media varies depending on
whether you are using the installed auto take-up reel
unit or the optional auto take-up reel unit for heavy
media.
Follow the steps below when using the standard auto
take-up reel unit.
When the Heavy Roll Auto Take-up Reel Unit is
installed U
"Using the Optional Heavy Roll Auto
Take-up Reel Unit" on page 41
When the Standard Auto Take-up
Reel Unit Is Installed
This section describes how to remove media from the
take-up reel.
!
Caution:
❏ Because the media is heavy, it should not be
carried by one person. When loading or
removing the media, use at least two persons.
❏ Perform the following procedure to properly
remove the take-up roll.
Injury may occur if the take-up roll falls.
A
Cut the media and roll the cut end onto the
take-up reel.
"Cutting Media" on page 34
U
B
To prevent the media from sliding off the roll,
support the roll at its left end.
40
Advertisement
Table of Contents
