Using A Test Pattern - Epson SureColor SC-F7000 User Manual

SC-F7000 Series User's Guide

Using a Test Pattern

Buttons that are used in the following settings
A
After confirming that the printer is ready, press
the Menu button.
The settings menu will be displayed.
B
Select Media Setup and press the Z button.
C
Use the d/u buttons to select Customize
Settings and press the Z button.
D
Use the d/u buttons to select a media setting
bank number between 1 and 30 and then press
the Z button.
Note that any settings already saved in the printer
will be overwritten.
E
Use the d/u buttons to select Feed Adjustment
and press the Z button.
F
Select Manual and press the Z button.
G
Use the d/u buttons to select a test pattern and
press the Z button twice.
The longer the pattern, the more accurate the
adjustment.
Basic Operations
H
The printer will print a test pattern.
When printing is complete, the media will
automatically be fed to a position where the
pattern is clearly visible.
I
Measure the distance between the "+" symbols.
Record either the distance between the two
center symbols or the average of the distances
between the left, center, and right symbols.
J
Pattern length is displayed in the control panel.
Using the d/u buttons, enter the value recorded
in Step 10 and press the Z button.
Note:
To rewind the media, press u. Stop rewinding
before the media is past the cutter groove (on the
pressure roller side).
If the leading edge of the media is curled, stop
rewinding before the media reaches the inner side
of the front cover.
47