Table of Contents
Advertisement
SC-F7000 Series
User's Guide
Printing does not stop when the roll
ends
Is Off selected for Tension Measurement?
o
Periodically is recommended in most circumstances.
"Tension Measurement" on page 45
U
Removing Jammed Media
Follow the steps below to remove jammed media.
!
Caution:
Be careful not to trap your hands or fingers when
opening or closing the front cover. Failure to
observe this precaution could result in injury.
A
Open the front cover.
B
Turn off the printer.
If a message is displayed and the printer will not
turn off, unplug the power cable.
C
Remove the media holding plates, if installed.
Problem Solver
c
Important:
Cease use of the printer if the media holding
plates are deformed. Continued use could
damage the pressure rollers or print head.
Contact your dealer or Epson Support.
D
If the print head is over the media, move it away
from the jam.
c
Important:
Move the print head only after removing the
media holding plates. Contact with deformed
media holding plates could damage the print
head.
E
Raise the media loading lever.
F
Pull the media to the cutter groove and use a
cutter to remove torn or creased portions.
G
Manually rewind the cut media.
83
Advertisement
Table of Contents
