Line Preview (V2) - Siemens OpenStage 40 Administration Manual

administration.fm
Administration
Multiline Appearance/Keyset
3.9.3

Line Preview (V2)

This key enables the preview mode, which allows the user to preview a line before using it.
When preview mode is active, the line keys behave similar to when the keyset configuration is
set to preselection for line keys (see Section 3.9.2, "Configure Keyset Operation"). On pressing
the line key (not DSS key!), the call activity on the corresponding line is shown. Unlike with a
preselected line, there will be no change to the phone's current line connections. The LED in-
dicates whether line preview is active or not.
The information shown to the user depends on the ring/alert configuration for the line in ques-
tion. If the line is configured to alert only, the preview will only show the state of the call, not the
identity of the call party. If the line is configured to ring, the identity of the call party will be re-
vealed.
The preview mode can be configured as temporary or as permanent. If System > Features >
Keyset operation > Preview mode is disabled, preview mode will end when the user uses the
previewed line, or a new call is started in any other way, or if the focus is changed away from
call view. If the parameter is enabled, preview mode remains active until the user cancels it by
pressing the key again.
The Preview timer parameter determines the timespan during which the line preview will re-
main on the screen.
Administration via WBM
System > Features > Program keys > Preview
A31003-O1010-M100-17-76A9, 09/09/2010
3-110
OpenScape Voice - OpenStage Family, Administration Manual