Set The Terminal Number; Basic Network Configuration - Siemens OpenStage 40 Administration Manual

2.3.2

Set the Terminal Number

If the user and administrator menus are needed in the course of setup, the terminal number,
which by default is identical with the phone number, must be configured first. When the phone
is in delivery status, the terminal number input form is presented to the user/administrator right
after booting, unless the Plug&Play facility of the DLS is used. For further information about this
setting, please refer to Section 3.5.1.1, "Terminal Identity". With the WBM, the terminal number
is configured as follows:
In the left column, select System > System Identity to open the "System Identity" dialog. Enter
the terminal number, i. e. the SIP name / phone number.
2.3.3

Basic Network Configuration

For basic functionality, DHCP must provide the following parameters:
• IP Address: IP Address for the phone.
• Subnet Mask (option #1): Subnet mask of the phone.
• Default Route (option #3 "Router"): IP Address of the default gateway which is used for
connections beyond the subnet.
• DNS IP Addresses (option #6 "Domain Server"): IP Addresses of the primary and
secondary DNS servers.
If no DHCP server is present, see Section 3.3.3, "IP Address - Manual Configuration" for IP ad-
dress and subnet mask, and Section 3.3.4, "Default Route/Gateway" for the default route.
A31003-O1010-M100-17-76A9, 09/09/2010
OpenScape Voice - OpenStage Family, Administration Manual
inbetriebnahme.fm
Startup
Quick Start
2-9