Configure Keyset Operation - Siemens OpenStage 40 Administration Manual

3.9.2

Configure Keyset Operation

The following parameters provide general settings which are common for all keyset lines.
The Rollover ring setting will be used when, during an active call, an incoming call arrives on
a different line. If "no ring" is selected, the incoming call will not initiate a ring. If "alert ring" is
selected, a 3 seconds burst of the configured ring tone is activated on an incoming call; "alert
beep" selects a beep instead of a ring tone. "Standard ring tone" selects the default ringer.
LED on registration determines whether the line LEDs will be lit for a few seconds if they have
been registered successfully with the SIP server on phone startup.
The Originating line preference parameter determines which line will be used when the user
goes off-hook or starts on-hook dialing.
When a terminating call exists, the terminating line preference takes priority over
>
originating line preference.
The following preferences can be configured:
• "idle line": An idle line is selected. The selection is based on the Hunt ranking
parameter assigned to each line (see Section 3.9.1, "Line key configuration").
• "primary": The designated Primary Line/Main DN is always selected for originating
calls.
• "last": The line selected for originating calls is the line that has been used for the last
call (originating or terminating).
• "none": The user manually selects a line by pressing its line key before going off-hook,
or by pressing the speaker key, to originate a call. Manual line selection overrides au-
tomatic line preferences.
The Terminating line preference parameter decides which terminating line, i. e. line with an
incoming call, is selected when the user goes off-hook.
The following preferences can be configured:
• "ringing line": The line in the alerting or audible ringing state is automatically selected
when the user goes off-hook. In the case of multiple lines alerting or ringing, the lines
are selected on the one that has been alerting the longest.
• "ringing PLP": The line in the alerting or audible ringing state is automatically selected
when the user goes off-hook. However, if the prime line is alerting, it is given priority.
• "incoming": The earliest line to start audible ringing is selected, or else the earliest
alerting (ringing suppression ignored) line is selected.
A31003-O1010-M100-17-76A9, 09/09/2010
OpenScape Voice - OpenStage Family, Administration Manual
administration.fm
Administration
Multiline Appearance/Keyset
3-105