Canon NP7160 Service Manual page 70

CHAPTER 3 EXPOSURE SYSTEM
10) Remove the three mounting screws [4],
and detach the motor base [5] and the
timing belt [6].
Caution:
When detaching the motor base, be
sure to mark its position at its four
corners. When mounting it, on the
other hand, be sure to refer to these
markings.
11) Holding the bent [A], pull the scanner
until it reaches the hole [B]; then, remove
the two screws [7].
12) Remove the two tension springs [8], and
detach the scanner drive cable (front) [9]
and the scanner drive cable (rear) [10].
3–14
COPYRIGHT © 1998 CANON INC.
[6]
[7]
[9]
CANON NP7161/NP7160 REV.0 AUG. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
[4] [5]
Figure 3-504
[7]
[B]
[A]
Figure 3-505
[10]
[8]
Figure 3-506