CHAPTER 10 TROUBLESHOOTING
b. AE Scanning Intensity Adjustment
If an optimum image cannot be obtained by executing '301' (AE auto adjustment) in service
mode, perform the following:
1) Place a white background original on the copyboard glass, and select AE and Direct.
2) Make a copy, and check the copy image.
3) Select '302' (AE scanning intensity adjustment) in service mode.
• The copy count indicator will indicate the present setting.
4) Change the setting using the keypad or the +/- key.
[1] A higher setting will increase the intensity, making the copy image lighter.
[2] A lower setting will decrease the intensity, making the copy image darker.
5) Press the Start key to store the new setting.
• Repeat steps 2) through 5) until an optimum image is obtained.
6) Press the Reset key to end service mode.
10–20
COPYRIGHT © 1998 CANON INC.
Intensity
Copy
density
Test Chart
Figure 10-226
CANON NP7161/NP7160 REV.0 AUG. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
[1]
[2]
Original
density