Saving Configuration Changes; Verifying The Configuration - Cisco MWR 1941-DC - 1941 Mobile Wireless Router Software Configuration Manual

Saving Configuration Changes

Saving Configuration Changes
To prevent the loss of the router configuration, save it to non-volatile random access memory (NVRAM).
To save the configuration to NVRAM, do the following:
Exit configuration mode.
Step 1
Router(config)# exit
Note
Save the configuration changes to NVRAM so that they are not lost during resets, power cycles, or power
Step 2
outages.
Router# copy running-config startup-config

Verifying the Configuration

To verify the configuration of the MWR 1941-DC, enter the following command:
MWR1900-1#show running-config
hostname MWR1900-1
!
boot system slot0:mwr-1900-boot
!
! description Loopback IP for O & M
!
interface loopback 0
ip address 10.1.170.3 255.255.255.255
!
! description Loopback IP for IP Unnumbered
!
interface loopback 2
ip address 192.168.170.2 255.255.255.255
!
interface loopback101
description Health Loopback Interface
no ip address
!
interface loopback102
description Revertive Loopback Interface
no ip address
!
enable password cisco
!
memory-size iomem 25
!
redundancy
mode y-cable
standby use-interface Loopback101 health
standby use-interface Loopback102 revertive
standby use-interface Multilink2 backhaul
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
4-24
You can press Ctrl-z in any mode to immediately return to enable mode (
of entering exit, which returns you to the previous mode.
Chapter 4 Configuring the MWR 1941-DC in an IP-RAN
Router#
), instead
78-13983-08