Cisco MWR 1941-DC - 1941 Mobile Wireless Router Software Configuration Manual page 148

Configuring the NM-AIC-64, Contact Closure Network Module
line 33
no exec
transport preferred none
transport input telnet
transport output none
stopbits 1
line aux 0
line vty 0 4
login
!
end
IP Route to the AIC Configuration Examples
Following examples show the configuration of an IP route to the AIC with an unnumbered and numbered
IP address.
With an Unnumbered IP Address
The following example shows a Cisco router, with an IP route to an AIC, is configured with an
unnumbered IP address:
version 12.1
no service single-slot-reload-enable
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname uut2-RouterB
!
logging rate-limit console 10 except errors
no logging console
!
ip subnet-zero
!
!
no ip finger
no ip domain-lookup
!
call rsvp-sync
cns event-service server
!
interface FastEthernet0/0
ip address 10.2.130.2 255.255.0.0
duplex auto
speed auto
no cdp enable
!
interface Serial5/0
ip unnumbered FastEthernet0/0
!
ip kerberos source-interface any
ip classless
ip route 0.0.0.0 0.0.0.0 10.2.0.1
ip route 10.2.130.102 255.255.255.255 Serial5/0
ip http server
!
no cdp run
!
alarm-interface 5
ip address 10.2.130.102
!
dial-peer cor custom
!
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
6-40
Chapter 6 Configuring the MWR 1941-DC in a Cell Site DCN
OL-11503-01