Cisco Ios Software Features - Cisco MWR 1941-DC - 1941 Mobile Wireless Router Software Configuration Manual

Mobile wireless edge router
Hide thumbs Also See for MWR 1941-DC - 1941 Mobile Wireless Router:
Table of Contents

Advertisement

Cisco IOS Software Features

Cisco IOS Software Features
There are two versions of software available for the Cisco MWR 1941-DC router. One version of
software is required for implementing the Cisco MWR 1941-DC router in an IP RAN; the other for
implementing the router in a Cell Site DCN.
The software features vary depending on the version of software running on the MWR 1941-DC router.
Software Features for the IP-RAN Implementation
The software required for implementing the MWR 1941-DC router in an IP-RAN consists of two
components: Cisco IOS software running on the MIPs-based route processor portion of the
MWR 1941-DC router hardware, and microcode running on the Cisco network processor, also known as
"Parallel eXpress Forwarding (PXF)." When deployed in an IP-RAN, the MWR 1941-DC router is
customized for performance, high availability, quality of service, and link efficiency.
Cisco IOS software functions added to the MWR 1941-DC router for the IP-RAN implementation
include:
This section contains the following information:
MIPs-Based Software Features
Standard Cisco IOS software features supported in the MWR 1914-DC router for the IP-RAN
implementation include:
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
1-4
Software Features for the IP-RAN Implementation, page 1-4
Software Features for the Cell Site DCN Application, page 1-8
Redundancy logic—For monitoring Hot Standby Routing Protocol (HSRP) information to
determine the active and standby router and control T1 termination.
Failover logic—To force a switchover for hardware failures or an over-temperature condition.
Relay control—To open and close the T1/E1 interfaces on the active and standby routers.
Diagnostic functions—To monitor the "health" of the standby MWR 1941-DC router.
MIPs-Based Software Features, page 1-4
Network Processor (PXF) Software Features, page 1-5
Redundancy Support, page 1-6
IP-RAN Implementation Updates, page 1-7
IP Fragmentation
IP Multicast
IGMP
MLP, PPP Control Path (IPCP, NCP, LCP, CLNS)
ACFC and PFC Handling During PPP Negotiation
HSRP
OSPF
DHCP
Chapter 1
Overview of the Cisco MWR 1941-DC Router
OL-11503-01

Advertisement

Table of Contents
loading

Table of Contents