Assigning A Qos Boilerplate To An Interface; Configuration Example - Cisco MWR 1941-DC - 1941 Mobile Wireless Router Software Configuration Manual

Chapter 6 Configuring the MWR 1941-DC in a Cell Site DCN
Repeat
Step 4
Exit policy map configuration mode.
Step 5
Router(config-pmap-c)# exit
Router(config-pmap)# exit

Assigning a QoS Boilerplate to an Interface

To assign a QoS boilerplate to an interface, do the following in global configuration mode.
Step 1 Access interface configuration mode.
Router(config)# interface number
Assign the QoS boilerplate to the interface.
Step 2
Router(config-if)# service-policy output policy_name

Configuration Example

The following is an example configuration of QoS configured on the MWR 1941-DC router in a Cell
Site DCN.
class-map match-all voice-class
match protocol rtp
class-map match-all nm-class
match protocol snmp
match protocol syslog
class-map match-all data-class
match protocol telnet
match protocol ftp
match protocol http
!
policy-map proto
class nm-class
class data-class
class voice-class
OL-11503-01
Step 2 and Step 3 for each class map.
bandwidth percent 20
queue-limit 300
bandwidth percent 40
queue-limit 300
bandwidth percent 40
queue-limit 300
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
Configuring QoS Attributes
6-45