Configuring Ppp Multiplexing - Cisco MWR 1941-DC - 1941 Mobile Wireless Router Software Configuration Manual

Configuring Multilink Interfaces
To configure IP address assignment, do the following do the following while still in multilink interface
configuration mode:
Specify an IP address, an address from a specific IP address pool, or an address from the Dynamic Host
Step 1
Configuration Protocol (DHCP) mechanism to be returned to a remote peer connecting to this interface:
RPM-3(config-if)# peer default ip address {ip-address | dhcp | pool [pool-name]}

Configuring PPP Multiplexing

To enable and control the multiplexing of PPP frames, do the following while still in multilink interface
configuration mode:
Enable PPP multiplexing:
Step 1
RPM-3(config-if)# ppp mux
Specify the parameters of multiplexing.
Step 2
To set the maximum time delay, enter:
RPM-3(config-if)# ppp mux delay integer
To set the maximum length of the subframe, enter:
RPM-3(config-if)# ppp mux subframe length integer
To set maximum length of the superframe, enter:
RPM-3(config-if)# ppp mux frame integer
To set the maximum number of subframes in a superframe, enter:
RPM-3(config-if)# ppp mux subframe count integer
To set the default PPP protocol ID, enter:
RPM-3(config-if)# ppp mux pid integer
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
4-10
Chapter 4 Configuring the MWR 1941-DC in an IP-RAN
78-13983-08