Configuration Examples - Cisco MWR 1941-DC - 1941 Mobile Wireless Router Software Configuration Manual

Configuring T1 and E1 Interfaces
Command
Router(config)# connect id {T1 | E1}
Step 4
slot/port-1
tdm-group-no-1 {T1 | E1} slot/port-2
tdm-group-no-2
Step 5
Router(config-controller)# exit
Step 6
Router(config)# connect id {T1 | E1}
slot/port-1 tdm-group-no-1 {T1 | E1}
slot/port-2 tdm-group-no-2

Configuration Examples

T1 Controller
The following is a sample configuration of an individual T1 controller from the show running-config
command output:
controller T1 0/0
framing esf
clock source internal
linecode b8zs
cablelength short 133
channel-group 0 timeslots 1-24 speed 64
Drop and Insert
The following is a sample drop and insert configuration from the show running-config command
output:
controller E1 0/0
clock source internal
channel-group 0 timeslots 1-5
tdm-group 2 timeslots 6-24
!
controller E1 0/1
clock source internal
tdm-group 1 timeslots 6-24
connect E1_TDM E1 0/0 2 E1 0/1 1
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
6-16
Chapter 6 Configuring the MWR 1941-DC in a Cell Site DCN
Purpose
This global configuration command sets up the
connection between two T1 or E1 TDM groups of
timeslots on the VWIC—for Drop and Insert.
id is a name for the connection.
Identify each controller by its slot/port location.
tdm-group-no-1 and tdm-group-no-2 identify the
TDM group numbers (from 0 to 23 or 30) on the
specified controller. The groups were set up in
Step 1.
Exit controller configuration mode. Skip the next
step if you are not setting up Drop and Insert.
This global configuration command sets up the
connection between two T1 or E1 TDM groups of
timeslots on the VWIC—for Drop and Insert.
id is a name for the connection.
Identify each controller by its slot/port location.
tdm-group-no-1 and tdm-group-no-2 identify the
TDM group numbers (from 0 to 23 or 30) on the
specified controller. The groups were set up in
Step 1.
OL-11503-01