Saving Configuration Changes; Where To Go Next - Cisco 1812W - Integrated Services Router Wireless Configuration Manual

Appendix A Cisco IOS Software Basic Skills

Saving Configuration Changes

You need to enter the copy running-config startup-config command to save your configuration
changes to nonvolatile RAM (NVRAM) so that they are not lost if there is a system reload or power
outage. This example shows how to use this command to save your changes:
router# copy running-config startup-config
Destination filename [startup-config]?
Press Return to accept the default destination filename startup-config, or enter your desired destination
filename and press Return.
It might take a minute or two to save the configuration to NVRAM. After the configuration has been
saved, the following message appears:
Building configuration...
router#
Summary
Now that you have reviewed some Cisco IOS software basics, you can begin to configure your router.
Remember:
•
•
•
•

Where to Go Next

To configure your router, go to
Network Deployments."
OL-6426-02
You can use the question mark (?) and arrow keys to help you enter commands.
Each command mode restricts you to a set of commands. If you are having difficulty entering a
command, check the prompt, and then enter the question mark (?) for a list of available commands.
You might be in the wrong command mode or using the wrong syntax.
If you want to disable a feature, enter the keyword no before the command; for example, no ip
routing.
Save your configuration changes to NVRAM so that they are not lost if there is a system reload or
power outage.
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
Chapter 1, "Basic Router Configuration,"
Saving Configuration Changes
and Chapter 2, "Sample
A-7