Cisco MWR 1941-DC - 1941 Mobile Wireless Router Software Configuration Manual page 90

mode y-cable
mode y-cable
To access the command mode that allows you to manually control the relays on the VWIC card, use the
mode y-cable command.
Syntax Description
This command has no parameters, it invokes the y-cable mode.
Defaults There are no default settings or behaviors.
Command Modes
Redundancy configuration
Command History Release
12.2(8)MC2
12.2(15)MC1
12.3(11)T
Examples The following example enables y-cable mode.
mode y-cable
Related Commands Command
standalone
standby use-interface
redundancy
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
5-10
mode y-cable
Modification
This command was introduced.
This command was incorporated in Cisco IOS 12.2(15)MC1.
This command was incorporated in Cisco IOS 12.3(11)T.
Chapter 5 Cisco MWR 1941-DC Router IP-RAN Command Reference
Description
Indicates whether the MWR 1941-DC router is being used as a
standalone device and manually sets the relays.
Designates a loopback interface as a health or revertive interface.
Invokes redundancy mode.
OL-11503-01