Configuring Scrambling For E3; Configuration Examples - Cisco MWR 1941-DC - 1941 Mobile Wireless Router Software Configuration Manual

Configuring the 1 T3/E3 Module

Configuring Scrambling for E3

To enable encryption of the payload on the E3 controller, complete the following tasks beginning in
global configuration mode.
Command
Step 1
interface serial slot/port
Example:
Router(config)# interface serial 1/0
Step 2
scramble
Example:
Router(config-if)# scramble
Step 3
exit
Example:
Router(config-if)# exit

Configuration Examples

T3 Controller
The following is sample output from the show running-config command for a T3 controller:
card type t3 1
controller T3 1/0
cablelength 10
interface Serial1/0
no ip address
no ip route-cache
no ip mroute-cache
no keepalive
dsu bandwidth 44210
E3 Controller
The following is sample output from the show running-config command for an E3 controller:
card type e3 1
controller E3 1/0
interface Serial1/0
ip address 10.0.0.6 255.255.255.0
encapsulation ppp
no keepalive
dsu bandwidth 34010
no cdp enable
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
6-22
Chapter 6
Purpose
Enters interface configuration mode.
Enables the scrambling of the payload.
Default is off.
•
Exits interface configuration mode and returns the router to
privileged EXEC mode.
Configuring the MWR 1941-DC in a Cell Site DCN
OL-11503-01