Cisco MWR 1941-DC - 1941 Mobile Wireless Router Software Configuration Manual page 51

Configuring the MWR 1941-DC in an IP-RAN
Cisco IOS Release 12.3(11)T supports the Cisco IOS IP-RAN feature set (software image) for the
Note
MWR 1941-DC router.
This chapter describes how to use the Cisco IOS software command-line interface (CLI) to configure the
following features of the Cisco MWR 1941-DC in an IP-RAN:
• Before You Begin, page 4-2
Verifying the Version of Cisco IOS Software, page 4-2
•
• Configuring the Host Name and Password, page 4-2
Configuring Multilink Interfaces, page 4-8
•
Configuring Fast Ethernet Interfaces, page 4-4
•
Configuring Multilink Interfaces, page 4-8
•
Configuring T1 and E1 Interfaces, page 4-14
•
Configuring QoS Attributes, page 4-17
•
Configuring Redundancy, page 4-20
•
Configuring the Link Noise Monitor, page 4-21
•
Saving Configuration Changes, page 4-24
•
Verifying the Configuration, page 4-24
•
Monitoring and Managing the MWR 1941-DC, page 4-28
•
• Where to Go Next, page 4-30
Follow the procedures in this chapter to configure the router manually or if you want to change the
configuration after you have run the setup command facility (described in Chapter 1, "First-Time
Configuration").
This chapter describes how to configure features related to the use of the MWR 1941-DC in an IP-RAN.
For additional configuration topics, refer to the Cisco IOS configuration guide and command reference
publications. These publications are available on the Documentation CD-ROM that came with your
router, on the World Wide Web from Cisco's home page, or you can order printed copies separately.
If you skipped the previous chapter,
Note
configured a Cisco router, go back to that chapter and read it now. The chapter contains important
information you need to successfully configure your router.
78-13983-08
Chapter 2, "Cisco IOS Software Basics,"
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
C H A P T E R
and you have never
4
4-1