Table of Contents
Advertisement
Quick Links
Regulatory Compliance and Safety Information
for the Cisco MWR 1900 Mobile Wireless Edge
Router
Product Numbers: MWR-1900-27
This document provides international agency compliance, safety, and statutory information for the Cisco
MWR 1900 Mobile Wireless Edge Router.
Contents
This document contains the following sections:
Regulatory Standards Compliance, page 2
•
•
Operating Conditions for Canada, page 5
Operating Conditions for the European Community, page 6
•
•
Translated Safety Warnings, page 6
•
Obtaining Documentation, page 25
Obtaining Technical Assistance, page 26
•
Corporate Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Copyright © 2002. Cisco Systems, Inc. All rights reserved.
Advertisement
Table of Contents
Related Manuals for Cisco MWR-1900-27
Summary of Contents for Cisco MWR-1900-27
-
Page 1: Regulatory Compliance And Safety Information
• Translated Safety Warnings, page 6 • Obtaining Documentation, page 25 Obtaining Technical Assistance, page 26 • Corporate Headquarters: Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA Copyright © 2002. Cisco Systems, Inc. All rights reserved. -
Page 2: Table Of Contents
Regulatory Standards Compliance Regulatory Standards Compliance The Cisco MWR 1900 router is in compliance with the national and international standards described in Table Table 1 Class A Regulatory Standards Compliance Specification Regulatory Compliance Safety Immunity Telecom (E1) Telecom (T1) 1. For specifics on the Cisco MWR 1900 router JATE approval, see the page The Cisco MWR 1900 router complies with the following standards: •... -
Page 3: Fcc Class A Compliance
If you have trouble with this equipment, please contact Cisco Systems for repair and warranty information. If the trouble is causing harm to the telephone network, the telephone company can request that you remove the equipment from the network until the problem is resolved. -
Page 4: Emc Environmental Conditions
Regulatory Standards Compliance The facility interface and service order codes are shown in Cisco MWR-1900-27 routers (bearing labeling identification number US:5B1DDNAN0006) comply with the following requirements: FCC Rules and Regulations 47 CFR Part 68 • TIA/EIA/IS-968, Technical Criteria for Terminal Equipment to Prevent Harms to the Telephone •... -
Page 5: Cispr 22 Class A Warning
the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.” [cfr reference 15.105] CISPR 22 Class A Warning For CISPR22 Class A, the following warning is provided:... -
Page 6: Operating Conditions For The European Community
Operating Conditions for the European Community Repairs to certified equipment should be made by an authorized Canadian maintenance facility • designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment. - Page 7 Warning This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing accidents. To see translations of the warnings that appear in this publication, refer to the Regulatory Compliance and Safety Information document that accompanied this device.
-
Page 8: Installation Warning
Translated Safety Warnings Aviso Este símbolo de aviso indica perigo. Encontra-se numa situação que lhe poderá causar danos físicos. Antes de começar a trabalhar com qualquer equipamento, familiarize-se com os perigos relacionados com circuitos eléctricos, e com quaisquer práticas comuns que possam prevenir possíveis acidentes. -
Page 9: Restricted Area Warning
Installation Warning—Qualified Personnel Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Waarschuwing Deze apparatuur mag alleen worden geïnstalleerd, vervangen of hersteld door bevoegd geschoold personeel. Varoitus Tämän laitteen saa asentaa, vaihtaa tai huoltaa ainoastaan koulutettu ja laitteen tunteva henkilökunta. - Page 10 Translated Safety Warnings Warning This unit is intended for installation in restricted access areas. A restricted access area is where access can only be gained by service personnel through the use of a special tool, lock and key, or other means of security, and is controlled by the authority responsible for the location.
-
Page 11: Jewelry Removal Warning
Jewelry Removal Warning Before working on equipment that is connected to power lines, remove jewelry (including rings, Warning necklaces, and watches). Metal objects will heat up when connected to power and ground and can cause serious burns or weld the metal object to the terminals. Waarschuwing Alvorens aan apparatuur te werken die met elektrische leidingen is verbonden, sieraden (inclusief ringen, kettingen en horloges) verwijderen. -
Page 12: Power Supply Disconnection Warning
Translated Safety Warnings Power Supply Disconnection Warning Before working on a chassis or working near power supplies, unplug the power cord on AC Warning units; disconnect the power at the circuit breaker on DC units. Waarschuwing Voordat u aan een frame of in de nabijheid van voedingen werkt, dient u bij wisselstroom toestellen de stekker van het netsnoer uit het stopcontact te halen;... -
Page 13: Power Supply Warning
Power Supply Warning Do not touch the power supply when the power cord is connected. For systems with a power Warning switch, line voltages are present within the power supply even when the power switch is off and the power cord is connected. For systems without a power switch, line voltages are present within the power supply when the power cord is connected. -
Page 14: Grounded Equipment Warning
Translated Safety Warnings ¡Advertencia! No tocar la fuente de alimentación mientras el cable esté enchufado. En sistemas con interruptor de alimentación, hay voltajes de línea dentro de la fuente, incluso cuando el interruptor esté en Apagado (OFF) y el cable de alimentación enchufado. En sistemas sin interruptor de alimentación, hay voltajes de línea en la fuente cuando el cable está... -
Page 15: Ground Connection Warning
Ground Connection Warning Warning When installing the unit, always make the ground connection first and disconnect it last. Waarschuwing Bij de installatie van het toestel moet de aardverbinding altijd het eerste worden gemaakt en het laatste worden losgemaakt. Varoitus Laitetta asennettaessa on maahan yhdistäminen aina tehtävä ensiksi ja maadoituksen irti kytkeminen viimeiseksi. - Page 16 Translated Safety Warnings Circuit Breaker (15A) Warning This product relies on the building's installation for short-circuit (overcurrent) protection. Warning Ensure that a UL Listed and Certified fuse or circuit breaker no larger than 60 VDC, 15 A is used on all current-carrying conductors. Waarschuwing Dit product is afhankelijk van de in het gebouw gebruikte installatie voor kortsluit- (overstroom)beveiliging.
-
Page 17: Power Cabling Warning
Power Cabling Warning Secure all power cabling when installing this unit to avoid disturbing field-wiring connections. Warning Waarschuwing Zet alle stroomkabels vast wanneer dit toestel wordt geïnstalleerd om te voorkomen dat de verbindingen van de veldbedrading worden verstoord. Varoitus Kiinnitä kaikki voimakaapelit tiukkaan tätä laitetta asentaessasi, jotta vältät kentän johdinkytkentöjen vioittumista. -
Page 18: Exposed Dc Power Wire Warning
Translated Safety Warnings Warnung Der Netzkabelanschluß am Gerät muß jederzeit zugänglich sein, weil er als primäre Ausschaltvorrichtung dient. Avvertenza Il gruppo spina-presa deve essere sempre accessibile, poiché viene utilizzato come dispositivo di scollegamento principale. Advarsel Kombinasjonen støpsel/uttak må alltid være tilgjengelig ettersom den fungerer som hovedfrakoplingsenhet. -
Page 19: Lightning Activity Warning
Aviso Um fio condutor exposto de uma unidade de entrada de DC (corrente contínua) pode transportar níveis perigosos de electricidade. Certifique-se de que nenhuma secção exposta de um fio condutor da fonte de energia de entrada de DC se extende a partir da ficha da placa de terminais. -
Page 20: Selv Circuit Warning
Translated Safety Warnings SELV Circuit Warning Warning The Ethernet 10/100BaseT, Token Ring, serial, console, and auxiliary ports contain safety extra-low voltage (SELV) circuits. BRI circuits are treated like telephone-network voltage (TNV) circuits. Avoid connecting SELV circuits to TNV circuits. Waarschuwing De 10/100BaseT-, de Token Ring- en de hulppoorten, de seriële poorten en de poorten op het console voor Ethernet zijn voorzien van veiligheidscircuits met extra laag voltage (SELV). - Page 21 DC Power Disconnection Warning—Transverter Warning Before performing any of the following procedures, ensure that DC power to the transverter you will be working on is turned OFF. To ensure that the power to the specific transverter is OFF, locate the power/breaker switch on the front of power feed panel that services that transverter, push the switch into the OFF position, then tape the switch in the OFF position.
- Page 22 Translated Safety Warnings ¡Advertencia! Antes de proceder con los siguientes pasos, comprobar que la alimentación del circuito de corriente continua (CC) con el que se va a trabajar esté cortada (OFF). Para ello, localizar el interruptor de corriente en la parte frontal del panel que alimenta al circuito, cambiar el interruptor automático a la posición de Apagado (OFF) y sujetar con cinta adhesiva la palanca del interruptor automático en posición de Apagado (OFF).
- Page 23 ¡Advertencia! Después de cablear la fuente de alimentación de corriente continua, retirar la cinta de la palanca del interruptor automático, y restablecer la alimentación cambiando la palanca a la posición de Encendido (ON). Varning! När du har kopplat ledningarna till strömförsörjningsenheten för inmatad likström tar du bort tejpen från överspänningsskyddets omkopplare och slår på...
- Page 24 Translated Safety Warnings Attention Pour éviter toute blessure corporelle pendant les opérations de montage ou de réparation de cette unité en casier, il convient de prendre des précautions spéciales afin de maintenir la stabilité du système. Les directives ci-dessous sont destinées à assurer la protection du personnel : •...
-
Page 25: Obtaining Documentation
Om ställningen är försedd med stabiliseringsdon skall dessa monteras fast innan enheten installeras eller underhålls på ställningen. Obtaining Documentation The following sections provide sources for obtaining documentation from Cisco Systems. World Wide Web You can access the most current Cisco documentation on the World Wide Web at the following sites: http://www.cisco.com... -
Page 26: Obtaining Technical Assistance
To submit your comments by mail, use the response card behind the front cover of your document, or write to the following address: Attn Document Resource Connection Cisco Systems, Inc. 170 West Tasman Drive San Jose, CA 95134-9883 We appreciate your comments. -
Page 27: Technical Assistance Center
Customers and partners can self-register on Cisco.com to obtain additional personalized information and services. Registered users can order products, check on the status of an order, access technical support, and view benefits specific to their relationships with Cisco. To access Cisco.com, go to the following website: http://www.cisco.com Technical Assistance Center The Cisco TAC website is available to all customers who need technical assistance with a Cisco product... - Page 28 Obtaining Technical Assistance Technical Assistance Center 78-13978-03...
- Page 29 Breakthrough, iQ Expertise, iQ FastTrack, the iQ Logo, iQ Net Readiness Scorecard, Networking Academy, ScriptShare, SMARTnet, TransPath, and Voice LAN are trademarks of Cisco Systems, Inc.; Changing the Way We Work, Live, Play, and Learn, Discover All That’s Possible, The Fastest Way to Increase Your Internet Quotient, and iQuick Study are service marks of Cisco Systems, Inc.;...
- Page 30 Obtaining Technical Assistance Technical Assistance Center 78-13978-03...