Configuring Acfc And Pfc Handling During Ppp Negotiation - Cisco MWR 1941-DC - 1941 Mobile Wireless Router Software Configuration Manual

Chapter 4 Configuring the MWR 1941-DC in an IP-RAN

Configuring ACFC and PFC Handling During PPP Negotiation

This feature requires Cisco IOS Release 12.2(15)MC1 and later be installed on the MWR 1941-DC
Note
router.
ACFC and PFC handling during PPP negotiation can be configured. By default, ACFC/PFC handling is
not enabled.
To configure ACFC handling during PPP negotiation, do the following while in multilink interface
configuration mode:
Enter the following command to configure how the router handles the ACFC option in configuration
Step 1
requests received from a remote peer.
RPM-3(config-if)# ppp acfc remote {apply | reject | ignore}
Where:
•
•
•
Enter the following command to configure how the router handles ACFC in its outbound configuration
Step 2
requests.
RPM-3(config-if)# ppp acfc local {request | forbid}
Where:
•
•
To configure PFC handling during PPP negotiation, do the following while in multilink interface
configuration mode:
Step 1 Enter the following command to configure how the router handles the PFC option in configuration
requests received from a remote peer.
RPM-3(config-if)# ppp pfc remote {apply | reject | ignore}
Where:
•
•
•
78-13983-08
apply—ACFC options are accepted and ACFC may be performed on frames sent to the remote peer.
reject—ACFC options are explicitly ignored.
ignore—ACFC options are accepted, but ACFC is not performed on frames sent to the remote peer.
request—The ACFC option is included in outbound configuration requests.
forbid—The ACFC option is not sent in outbound configuration requests, and requests from a
remote peer to add the ACFC option are not accepted.
apply—PFC options are accepted and ACFC may be performed on frames sent to the remote peer.
reject—PFC options are explicitly ignored.
ignore—PFC options are accepted, but ACFC is not performed on frames sent to the remote peer.
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
Configuring Multilink Interfaces
4-11