Cisco MWR 1941-DC - 1941 Mobile Wireless Router Software Configuration Manual page 100

show ppp mux
show ppp mux
To display counters for a multilink interface on the MWR 1941-DC, use the show ppp mux command
in EXEC mode.
Syntax Description
interface interface
Defaults If no interface is specified, statistics for all multilink and serial interfaces are displayed.
Command Modes
EXEC
Command History Release
12.2(8)MC2
12.2(15)MC1
12.3(11)T
Usage Guidelines This command is only valid when issued against multilink or PPP interfaces.
Examples The following is an example of the output generated by this command.
show ppp mux interface multilink 1
PPP Multiplex Statistics on Interface Multilink1:
Multiplex:
Total input packets:0
Errored input packets:0
Valid input bytes:0
Total output packets:0
Multiplexed output packets:0
Output bytes:0
Efficiency improvement factor:0%
Demultiplex:
Total input packets:0
Multiplexed input packets:0
Errored input packets:0
Valid input bytes:0
Total output packets:0
Output bytes:0
Efficiency improvement factor:0%
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
5-20
show ppp mux [interface interface]
(Optional) The identifier of the multilink or serial interface for which you
want to view counters.
Modification
This command was introduced.
This command was incorporated in Cisco IOS 12.2(15)MC1.
This command was incorporated in Cisco IOS 12.3(11)T.
Chapter 5 Cisco MWR 1941-DC Router IP-RAN Command Reference
OL-11503-01