Cisco MWR 1941-DC - 1941 Mobile Wireless Router Software Configuration Manual page 97

Chapter 5 Cisco MWR 1941-DC Router IP-RAN Command Reference
redundancy
To access the command mode that allows you to configure aspects of redundancy, use the redundancy
command.
Syntax Description
This command has no parameters, it invokes the redundancy mode.
Defaults There are no default settings or behaviors.
Command Modes
Global configuration
Command History Release
12.2(8)MC2
12.2(15)MC1
12.3(11)T
Examples The following example enables redundancy mode.
redundancy
Related Commands Command
mode y-cable
standalone
standby use-interface
OL-11503-01
redundancy
Modification
This command was introduced.
This command was incorporated in Cisco IOS 12.2(15)MC1.
This command was incorporated in Cisco IOS 12.3(11)T.
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
Description
Invoked y-cable mode.
Indicates whether the MWR 1941-DC router is being used as a
standalone device and manually sets the relays.
Designates a loopback interface as a health or revertive interface.
redundancy
5-17