Cisco MWR 1941-DC - 1941 Mobile Wireless Router Software Configuration Manual page 96

ppp mux subframe count
ppp mux subframe count
To set the maximum number of PPP subframes that can be contained in a superframe, use the ppp mux
subframe count command in interface configuration mode. To set the maximum number to the default,
use the no form of this command.
Syntax Description integer
Defaults The default maximum is 15.
Command Modes
Interface configuration
Command History Release
12.2(8)MC2
12.2(15)MC1
12.3(11)T
Usage Guidelines To use this command, you must first enable PPP multiplexing/demultiplexing.
Examples
The following example sets the maximum subframe count to 20 bytes.
ppp mux subframe count 20
Related Commands Command
ppp mux
ppp mux delay
ppp mux frame
ppp mux pid
ppp mux subframe length
show ppp mux
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
5-16
ppp mux subframe count integer
no ppp mux subframe count
The maximum number of subframes that can be contained in a superframe.
Possible values are 1 through 15 bytes.
Modification
This command was introduced.
This command was incorporated in Cisco IOS 12.2(15)MC1.
This command was incorporated in Cisco IOS 12.3(11)T.
Chapter 5 Cisco MWR 1941-DC Router IP-RAN Command Reference
Description
Enables PPP multiplexing/demultiplexing
Sets the maximum delay.
Sets the maximum length of the PPP superframe.
Sets the default PPP protocol ID.
Sets the maximum length of the PPP subframe.
Displays PPP mux counters for the specified multilink interface.
OL-11503-01