Cisco MWR 1941-DC - 1941 Mobile Wireless Router Software Configuration Manual page 150

Configuring the NM-AIC-64, Contact Closure Network Module
!
snmp-server packetsize 4096
snmp-server manager
!
!
alarm-interface 1
ip address 172.128.12.2
call rsvp-sync
!
dial-peer cor custom
!
line con 0
exec-timeout 0 0
transport input none
line 33
no exec
transport preferred none
transport input telnet
transport output none
stopbits 1
line aux 0
line vty 0 4
password lab
login
!
no scheduler allocate
!
end
AIC CLI Configuration for Alarms
These examples are output from the show alarm config # command.
Discrete Alarm
description:west door
normally closed
normal state description:door closed
alarm state description:door open
SNMP trap:enabled
Analog Alarm Monitoring Current
description:thermostat
high-high state description:very hot
high state description:hot
normal state description:just right
low state description:cold
low-low state description:very cold
current-loop -5.2 5.4 15.0 25.0 35.1 45.6
SNMP trap:enabled
Analog Alarm Monitoring Current Configured as a Discrete
description:east door
configured as discrete
normal state description:door closed
alarm description:door open
current-loop 0.0 3.2 5.9
SNMP trap:enabled
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
6-42
Chapter 6 Configuring the MWR 1941-DC in a Cell Site DCN
OL-11503-01