AT&T MERLIN Attendant System Manager's Manual page 38

Changing the Current Settings
3. Dial followed immediately by your authorized caller code and
*
The two-beep confirmation tone sounds.
Dial
4. 4
*
NOTE:
If you want to erase the announcements without reallocating time, skip
to step 6.
5. Perform all the steps below even if you are not using all the
announcements. For example, if you do not use the Night
announcement, enter 00. Be sure the total time allocated for all
announcements does not exceed 64 seconds.
Dial two digits representing the maximum length in seconds for the
a.
Day announcement.
b. Dial two digits representing the maximum length in seconds for the
Night announcement.
c. Dial two digits representing the maximum length in seconds for the
Transfer Fail announcement.
d. Dial two digits representing the maximum length in seconds for the
Hold announcement.
e. Dial two digits representing the maximum length in seconds for the
Connect announcement.
6. Dial .
#
The two-beep confirmation tone sounds.
7. Continue programming or exit authorized caller mode by dialing
8. To disconnect, dial
9
.
#
Changing Your Recorded Announcements
.
#
.
#
*
2-13