Changing The Clock For Daylight Saving Time - AT&T MERLIN Attendant System Manager's Manual

Changing the Current Settings
7. Continue programming or exit authorized caller mode by dialing
8. To disconnect, dial
Changing Clock for Daylight
the
Saving Time
To adjust the MERLIN Attendant's clock by one hour (for Daylight Saving
Time), use the following instructions.
1. Dial the MERLIN Attendant extension number from a Touch-Tone phone,
preferably a single-line set.
NOTE:
If you are programming from a multiline Touch-Tone phone connected
to a MERLIN LEGEND system control unit, you must enter an additional
each time a
#
2. Wait for an answer.
*
Dial
3.
The two-beep confirmation tone sounds.
4. Dial
*
Perform the appropriate procedure:
5.
— Dial 1 to add one hour to the current time (normally used in the
spring to begin Daylight Saving Time).
— Dial 2 to subtract one hour from the current time (normally used in the
fall to cancel Daylight Saving Time).
The two-beep confirmation tone sounds.
6. Continue programming or exit authorized caller mode by dialing
7. To disconnect, dial
.
#
appears in a programming command.
#
followed immediately by your authorized caller code and
.
7 2
.
#
Changing Your Business Hours
.
#
*
.
#
.
#
*
2-9