AT&T MERLIN Attendant System Manager's Manual page 36

Changing the Current Settings
1. Dial the MERLIN Attendant extension number from a Touch-Tone phone,
preferably a single-line set.
NOTE:
If you are programming from a multiline Touch-Tone phone connected
to a MERLIN LEGEND system control unit, you must enter an additional
each time a
#
Wait for an answer.
2,
3. Dial followed immediately by the authorized caller code and
*
The two-beep confirmation tone sounds.
4.
Dial
* 4
1 = Day
2 = Night
3 = Transfer Fail
4 = Hold
5 = Connect
5. Record the appropriate announcement.
6. When you are finished, dial
The two-beep confirmation tone sounds.
NOTE:
If there is a delay between the time you dial
confirmation tone, there is additional time allocated for this
announcement. To change the duration for this announcement, refer to
the information under "Erasing Announcements and Reallocating
Announcement Times. "
To play back any recorded announcement, dial
7.
code for the announcement you want to play back.
1 = Day
2 = Night
3 = Transfer Fail
appears in a programming command.
#
followed by a code for the announcement you want to record,
#
Changing Your Recorded Announcements
.
and hear the
#
followed by the
* 5
.
#
2-11