Changing The Authorized Caller Code - AT&T MERLIN Attendant System Manager's Manual

Changing the Current Settings

Changing the Authorized Caller Code

To prevent unauthorized changes to recorded announcements or
programmed settings, an authorized caller code must be entered before any
changes can be made to the programming of the MERLIN Attendant. The
default code number is 789 but it can be changed to any sequence of
numbers from one to 20 digits in length. Follow the procedure below to
change the code:
1. Dial the MERLIN Attendant extension number from a Touch-Tone phone,
preferably a single-line set.
NOTE:
If you are programming from a multiline Touch-Tone phone connected
to the MERLIN LEGEND system control unit, you must enter an
additional # each time a # appears in a programming command.
2. Wait for an answer.
Dial followed by the current authorized caller code and #
3.
*
The two-beep confirmation tone sounds.
Dial followed by the new authorized caller code you have chosen.
4.
6
#
#
Dial
5.
6.
Enter the new authorized caller code again.
7. #
Dial to confirm the new authorized caller code.
The two-beep confirmation tone sounds.
8. Continue programming or exit authorized caller mode by dialing
To disconnect, dial
9.
#
Changing the Authorized Caller Code
.
*
#
2-3