System Renumbering - AT&T Merlin II Release 3 System Manual

Stopwatch
DESCRIPTION
CONSIDERATIONS
How to Program
1 Label a button.
2 Enter programming mode by dialing #33.
3 Press the button you want to program.
4 Dial *92.
5 Leave programming mode by dialing #00.

System Renumbering

DESCRIPTION
CONSIDERATIONS
If you want to start and stop the timer on the display of your 7406D with
Display phone to time how long you spend on a call, for example, you can
use the Stopwatch feature. When you press a programmed Stopwatch
button, the Stopwatch activates the timer on your display screen.
This feature can be used only with the 7406D with Display phone.
The stopwatch feature starts the clock at :00 on the display and will count
to a maximum of 9:59:59 (hours: minutes: seconds). When you press the
Stopwatch button on your phone to stop the timer, the display disappears
immediately.
At some point, you may need to change modules in the control unit. If you
replace a module with one of a different type, you must readminister the
system to reassign numbers to lines and stations. Changing station modules
may also require readministration of features that are related to analog
stations only, such as attendant positions and the Voice Announcement to
Busy Telephone feature. Contact your authorized AT&T representative for
more information.
If you add a line or station module in the control unit, renumbering is not
necessary. However, you will need to assign the additional lines and stations
to individual phones.
How to Use
To start the timer on your display:
1 Press Stopwatch.
The timer on your display starts.
2 When you are finished, note the elapsed time
and record it, if necessary.
3 Press Stopwatch to turn off the display.
MERLIN II System Features
3-125