Kyocera ECOSYS FS-3140MFP Operation Manual page 374

Responding to an Error Lamp Flashes
If an error lamp flashes, press [Status/Job Cancel] to check an error message. If the message is not indicated on the
Message Display when [Status/Job Cancel] is pressed or the error lamp flashes for 1.5 seconds, check the following.
Symptom
Cannot send fax.
Checkpoints
Is the modular cord
connected correctly?
Is Permitted FAX No. or
Permitted ID No.
registered correctly?
Has a communication
error occurred?
Is the destination FAX line
busy?
Does the destination FAX
machine respond?
Is there an error other
than above?
Corrective Actions
Connect the modular cord
correctly.
Check Permitted FAX No.
and Permitted ID No..
Check error codes in the
TX/RX Result Report and
Activity Report. If the error
code starts with "U" or
"E", perform the
corresponding procedure.
Send again.
Send again.
Contact your Service
Representative.
10-12
Troubleshooting
Reference Page
—
FAX Operation Guide
Chapter 6 "Registering
Permit FAX No." and
"Registering Permit ID
No."
FAX Operation Guide
Appendix
"Error Code List"
—
—
—