Kyocera ECOSYS FS-3140MFP Operation Manual page 319

LAN Interface:
1 *Auto
*********************
2
10Base-Half
3
10Base-Full
TCP/IP (IPv4) Setup
Set up TCP/IP to connect to the Windows network. Set the IP addresses, subnet masks, and gateway addresses.
The default settings are "TCP/IP Protocol: On, DHCP: On, Bonjour: Off".
NOTE:
Prior to the IP address entries, obtain permission from the network administrator.
Use the procedure below to setup the TCP/IP (IPv4) setting.
Sys. Menu/Count.:a b
1
Report
2
Counter
3 System
*********************
Login User Name:
*******************
Login Password:
System:
1
Network Setting
*********************
2
I/F Block Set.
3 Security Level
6
Press the OK key. LAN Interface appears.
a b
7
Press the
interface.
The available LAN interfaces are as follows:
Auto
10Base-Half
10Base-Full
100Base-Half
100Base-Full
8
Press the OK key. Completed. is displayed and the
screen returns to the Network Setting menu.
1
In the Sys. Menu/Count. menu, press the
select [System], and press the OK key.
[ Exit ]
A login screen will appear. Then, enter the user ID and
L b
password with administrator privileges to log in, and
press [Login] (the Right Select key).
[ Login ]
2
The System menu appears.
a b
[ Exit ]
8-121
Default Setting (System Menu)
or key to select the desired LAN
8
or key to