Xerox 7300B - Phaser Color Laser Printer Service Manual page 47

Service Diagnostics Tests and Functions Table (cont'd.)
Menu Item
Registration
Entrance
Sensor
MPT Entrance
Sensor
transfer unit
Entrance
Sensor
Fuser Exit
Sensor
Face-Up Door
Switch
Stack Full
Sensor
Duplex Unit
Sensors
Color
Registration
Sensor
Density
Sensor
Media Weight
Sensor
Fuser Temp
Sensors
Ambient
Temp/Hum
Sensor
CMYK LED
Temp Sensor
CMYK IU
Sensor
Error Messages and Codes
Front Panel Display Results
Registration is Media Present / Not
Present
MPT Entrance Paper is Present / Not
Present
transfer unit Paper is Present / Not
Present
Fuser Exit Paper is Present / Not
Present
Face Up door is Open / Closed
Stack Full is Full / Not Full
Entrance Paper is Present / Not
Present
Middle Paper is Present / Not Present
Exit Paper is Present / Not Present
Color Reg. Front is nnnh
Color Reg. Rear is nnnh
Density is nnnh
Media Weight is nnnh
Fuser Temp Upper is nnn deg.C
Fuser Temp Lower is nnn deg.C
Fuser Temp (UpperSide) is nnn deg.C
Amb. Temp. is nnn deg.C
Amb. Hum. is nnn %
Black Temp is nnn (adc)
Yellow Temp is nnn (adc)
Magenta Temp is nnn (adc)
Cyan Temp is nnn (adc)
Cyan is Present / Missing
Magenta is Present / Missing
Yellow is Present / Missing
Black is Present / Missing
Functional Definition
Toggle the actuator to change
sensor state.
ENGINEERING USE ONLY
ENGINEERING USE ONLY
ENGINEERING USE ONLY
See "Fuser and Paper Exit" on
page 8-233 for information
regarding Fuser temperature
ranges.
See "Environmental Specifications"
on page 1-15 for the optimal printer
operating range.
ENGINEERING USE ONLY
Remove the Imaging Unit and
defeat the top cover interlock
switch and depress the 3-pins to
change state.
2-31