Xerox 7300B - Phaser Color Laser Printer Service Manual page 159

Replacement
Note: After replacing the Image Processor Board, print a
Configuration Page to verify printer options. Use the
previously printed Configuration Page to restore the
printer's configuration. If a Configuration Page could not
be printed, use CentreWare IS or CentreWare DP to
restore the settings.
1. Transfer the following items from the old board to the new board before installing
the new Image Processor Board.
RAM DIMMS
■
Optional Hard Drive
■
Configuration Chip
■
NVRAM chip.
■
RAM DIMMs (PL 3.2)
Warning: Switch off the power and disconnect the power cord.
RAMM SODIMMS are highly static sensitive devices.
Follow Electrostatic Discharge (ESD) precautions when
handling the RAMM SODIMMS.
1.
Spread apart the latches securing each end of the RAM SODIMM connector.
2. Lift the SODIMM out of the connector.
3. Reverse these steps to install the RAM SODIMM(s).
FRU Disassembly 6-143