Xerox 7300B - Phaser Color Laser Printer Service Manual page 135

c.
After the anvil is properly adjusted, tighten the screw and feed the
transparency the rest of the way through the registration roller to
remove it.
d. After installing the Pickup Plate and Cover Assemblies, verify the
sensor indicator is in the correct position as shown below. If not, use
the adjustment gear to raise or lower the indicator to the correct
position.
Caution Do not over torque the adjustment gear. This will break the
gear causing the indicator to no longer move up or down.
e.
Perform the 4-Sheet Calibration procedure after reassembly.
2. ATS 4-Sheet Calibration
a. Enter Service Diagnostics.
b. Scroll to
c. Select
ATS 4-Sheet Calibration
d.
Select
Edit Thickness Data
e. When prompted to
press OK.
f.
The printer enters the
g. Change the thickness value to 140, using the Up/Down keys to change
the first number to 1. Press the Information key to move the cursor to
the second digit, then the third digit. Once the value is set to 140 press
OK.
Note: The value set in Step g, 140 microns, is the average
thickness of Phaser 35-Series Premium Transparencies.
Using another type of transparency for this procedure will
produce inaccurate results or cause the calibration to fail.
h. Open the MPT and load 4 sheets of Phaser 35-Series Premium
Transparency.
Test Prints, Adjustments, and NVRAM Resets
Adjustments/Calibrations
Select thickness units
Edit Thickness Data
and press OK.
and press OK.
and press OK.
, select
menu.
S7300-118
and
microns
4-119