Calibrate Touch Screen; Network Setup - Xerox 6279 Printer User Manual

System Administration
6. Select Print Interrupt Timeout
The Print Interrupt Timeout screen displays.
7. Using either the scroll buttons or the numeric keypad, select the desired setting, and
then select Save.
8. Select Save to return to the Control Panel screen.

Calibrate Touch Screen

Your User Interface Touch Screen is calibrated when it is installed. Calibration aligns the
cursor to the place on the screen that you touch. The user interface does not typically
need to be recalibrated, unless it is not working correctly or you reinstall the controller.
1. Press the Services button on the Control Panel.
The Services menu screen displays.
2. Select Machine Info from the Services menu screen.
The Machine Info screen displays.
3. Select the Administration tab.
4. Select Control Panel.
5. Select Calibrate Touch Screen.
6. Press and hold your finger on the calibration symbol in each corner of the screen until
it moves to the next corner. It will touch all four corners.
7. Once the symbol moves to all four corners, the user interface prompts you to touch
anywhere on the screen to save the calibration data.
8. The User Interface saves the calibration data and displays the Control Panel screen.

Network Setup

Prior to being able to communicate with your FreeFlow Accxes scanner and printer, the
FreeFlow Accxes controller needs to be configured to the network.
The Network Setup settings allow the System Administrator to setup the following
TCP/IP settings:
• IP Address
• Gateway
• Submask
• DHCP
If you do not know the above information, perform the following steps to generate a
Configuration Report:
1. Select Machine Info on the Services menu.
2. Select the Print Reports tab.
3. Select Printer Configuration.
Instead of entering the IP Address, Subnet Mask, and Gateway Address, you may
enable Dynamic Host Configuration Protocol (DHCP) on the Network Setup screen.
3-20 ® ®
Xerox 6279 Wide Format Solution
Printer User Guide