Resetting Printer Values To The Factory Default Values; Resetting Connection Setup Values - Xerox Phaser 4500 Service Manual

Resetting Printer Values to the Factory Default
Values
You can reset printer values on the following menus to the factory default settings:
Connection Setup
Paper Handling Setup
PostScript Setup
PCL Setup
General Setup
Front Panel Setup
Printer Controls
File Security (available if the printer has a hard drive)
You can reset all of the Image Processor Board NVRAM-stored parameters to their
factory default values by resetting the PostScript NVRAM. Instructions for resetting
PostScript NVRAM are in "Resetting All Printer Default Settings (PostScript
NVRAM)" on page 6-14.
Note
There is no single reset for the Print Engine NVRAM.

Resetting Connection Setup Values

Resetting the connection setup values resets the Printer Name, TCP/IP address, TCP/
IP address menu settings (gateway, broadcast, etc.), CentreWare IS, EtherTalk,
NetWare, set IPX frame type, IPP, and Ethernet speed to their default values.
Caution
Before resetting the connection setup values to factory default values, make note
of the current network settings or print a Configuration Page to record the
printer's current network settings.
1.
From the Main Menu, select
2. Select Reset Connection
3. Select Reset Connection Setup
Adjustments and Calibrations
Connection Setup, then press the OK button.
Setup, then press the OK button.
NOW, then press the OK button.
6-11