Resetting Job Defaults; Resetting Network Setup Values To Default; Resetting Accumulator Belt Life - Xerox 7700DX - Phaser Color Laser Printer Service Manual

Resetting Job Defaults

Resetting the job defaults resets the paper source, paper destination, job
offset, stapling options, print-quality mode, 2-sided printing, image smoothing
and tekcolor corrections to their default values.
1. From the Main Menu, highlight Print Setup Menu and press OK.
2. Highlight Job Defaults Menu and press OK.
3. Reset Job Defaults is displayed, press OK.
4. Highlight Reset Job Defaults NOW and press OK to reset the job defaults.

Resetting Network Setup Values to Default

Resetting the network setup values resets the TCP/IP address, TCP/IP
address menu settings (gateway, broadcast, etc.), CentreWare IS, EtherTalk,
Netware, set IPX frame type, IPP and Ethernet speed to their default values.
1. From the Main Menu, highlight Network Setup Menu and press OK.
2. Highlight Reset Network Setup and press OK.
3. Reset Network Setup NOW is displayed, press OK.

Resetting Accumulator Belt Life

Resetting the Accumulator Belt life is to be performed only if the Accumulator
Belt Assembly was defective and or the assembly is replaced before an
end-of-life or near end-of-life message. Do not to extend the life of the
assembly. Doing so may cause premature failure of other internal printer
components.
The printer prompts the user to reset the life counts if the assembly is
replaced after receiving a Replace Accumulator Belt Assembly or Replace
Accumulator Belt Assembly Soon message.
1. From the Main Menu, highlight Supplies Info Menu and press OK.
2. Highlight Reset Accumulator Belt Life and press OK.
3. Reset Accumulator Belt Life NOW is displayed, press OK to reset the
Accumulator Belt life.
Phaser 7700 Color Laser Printer Service Manual 6-147