Module Logging; Facility Severity Levels - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Chapter 53 Configuring System Message Logging
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
To configure the severity level for a monitor session, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# logging monitor 3
switch(config)# no logging
monitor

Module Logging

By default, logging is enabled at level 7 for all modules. You can enable or disable logging for each
module at a specified level.
To enable or disable the logging for modules and configure the severity level, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# logging module 1
switch(config)# logging module
switch(config)# no logging module

Facility Severity Levels

To configure the severity level for a logging facility (see
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# logging level kernel 4
switch(config)# no logging level
kernel 4
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Purpose
Enters configuration mode.
Configures monitor logging at level 3 (error). Logging
messages with a severity level of 3 or above are displayed on
the monitor.
Reverts monitor logging to the factory set default severity level
of 5 (notifications). Logging messages with a severity level of
5 or above are displayed on the console.
Purpose
Enters configuration mode.
Configures module logging at level 1 (alerts) for all
modules.
Configures module logging for all modules in the switch at
the default level 5 (notifications).
Disables module logging.
Table 53-1), follow these steps:
Purpose
Enters configuration mode.
Configures Telnet or SSH logging for the kernel facility
at level 4 (warning). As a result, logging messages with
a severity level of 4 or above are displayed.
Reverts to the default severity level 6 (informational) for
the Telnet or SSH logging for the kernel facility.
Use the show logging info command to display
Note
the default logging levels for the facilities listed
in Table 53-1.
Cisco MDS 9000 Family CLI Configuration Guide
System Message Logging Configuration
53-5