Enabling Scsi Flow Configuration Distribution - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

SCSI Flow Services
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
To enable SCSI flow services, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# ssm enable feature scsi-flow
module 2
switch(config)# no ssm enable feature scsi-flow
module 2
switch(config)# no ssm enable feature scsi-flow
force module 2
Step 3
switch(config)# ssm enable feature scsi-flow
interface fc 2/5 - 8
switch(config)# no ssm enable feature scsi-flow
interface fc 2/5 - 8
switch(config)# no ssm enable feature scsi-flow
force interface fc 2/5 - 8

Enabling SCSI Flow Configuration Distribution

To enable SCSI flow configuration distribution using CFS, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# scsi-flow distribute
switch(config)# no scsi-flow distribute
Cisco MDS 9000 Family CLI Configuration Guide
47-4
Chapter 47 Configuring SCSI Flow Services and Statistics
Purpose
Enters configuration mode.
Enables SCSI flow services on the SSM in
slot 2.
Disables SCSI flow services on the SSM in
slot 2. The default is disabled.
Forces the switch to disable SCSI flow
services on the SSM in slot 2. The default is
disabled.
Enables SCSI flow services on interface 5
through 8 on the SSM in slot 2.
Interfaces must be specified in
Note
multiples of four beginning at ports 1,
5, 9, 13, 17, 21, 25, and 29.
Disables SCSI flow services on interface 5
through 8 on the SSM in slot 2. The default is
disabled.
Forces the switch to disable SCSI flow
services on the interface 5 through 8 on the
SSM in slot 2.
Purpose
Enters configuration mode.
Enables SCSI flow configuration distribution
through CFS. The default is enabled.
Disables CFS distribution for SCSI flow
configuration.
OL-16184-01, Cisco MDS SAN-OS Release 3.x