Configuring Santap; Enabling Santap - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Configuring SANTap

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Configuring SANTap
This section includes the following topics:
•
•

Enabling SANTap

SANTap can be enabled on an entire SSM or it can be enabled on a group of four ports on an SSM.
Enabling SANTap on interfaces has the following restrictions:
•
•
•
To enable the SANTap feature, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# ssm enable feature santap
module 4
switch(config)# no ssm enable feature santap
module 4
switch(config)# no ssm enable feature santap
force module 4
Step 3
switch(config)# ssm enable feature santap
interface fc 4/1 - 4
switch(config)# no ssm enable feature santap
interface fc 4/1 - 4
switch(config)# no ssm enable feature santap
force interface fc 4/1 - 4
Step 4
switch(config)# santap module 4 appl-vsan 10
switch(config)# no santap module 4 appl-vsan 10
You cannot simultaneously configure the intelligent services SANTap and NASB on a single SSM.
Note
Cisco MDS 9000 Family CLI Configuration Guide
49-4
Enabling SANTap, page 49-4
Configuring DVTs, page 49-5
The fewest number of interfaces that you can enable is four. You can specify fc1 through fc4 but not
fc1 through fc2.
The first interface in the group must be 1, 5, 9, 13, 17, 21, 25, or 29. You can specify fc5 through
fc8 but not fc7 through fc10.
The groups of four interfaces do not need to be consecutive. You can specify fc1 through fc8 and
fc17 through fc20.
Chapter 49
Purpose
Enters configuration mode.
Enables the SANTap application on the entire
SSM.
Disables the SANTap application on the entire
SSM in slot 4.
Forces the switch to disable the SANTap
application on the entire SSM in
slot 4.
Enables the SANTap application on ports 1
through 4 on the SSM.
Interfaces must be specified in
Note
multiples of four beginning at ports 1,
5, 9, 13, 17, 21, 25, and 29.
Disables the SANTap application on ports 1
through 4 on the SSM in slot 4.
Forces the switch to disable the SANTap
application on ports1 through 4 on the SSM in
slot 4.
Enables SANTap on the SSM in slot 4 and on
VSAN 10.
Disables SANTap.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Configuring SANTap